You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
-
-
TigrisJK replied to the thread 3D Print vs Stock vs Wood.Quick update, but not in a printing vein: I still use a cable at my desk, but I added a couple TRN BT30s to the build for using with...
-
TigrisJK replied to the thread 3D Print vs Stock vs Wood.I will! I'm probably going to play with materials a bit too. Been too busy to get around to it lately. Though I did make some mods to...
-
TigrisJK replied to the thread 3D Print vs Stock vs Wood.Thanks! I have but I didn't notice much difference there. I might play around with the diameter of the outside hole, cause I think that...
-
TigrisJK replied to the thread 3D Print vs Stock vs Wood.Made some modifications, the gimbals now fit with the rods perfectly (the rods self-tap into the gimbals with just a quick spin from a...
-
TigrisJK replied to the thread 3D Print vs Stock vs Wood.I got a little off the deep end. Prototyping flush fit cans for Grado 46mm drivers with gimbals. Things got crazy.
-
TigrisJK replied to the thread The discovery thread!.Whoops wrong thread, didn't see a delete option
-
TigrisJK posted a comment on the item OpenHeart OH2000.I mean I guess you don't have Grados so you couldn't say, but if anyone has these... Are the gimbals the right size to fit a Grado...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…