n0de5's latest activity
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.He said that he tested it but he probably stuck it into his ears for 2 seconds and pressed play on spotify and went, "Yep, this works."
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.Yea I tried and the right side DD is dead. Oh well. I'm going to scrap the drivers that work out of the ZS6 and use the metal shell for...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.I don't have a multimeter sadly. Do you know if this works without a Cr2032 battery? I believe they are 3.5v so I can find another...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.I did resolder the BAs but it appears that the 10mm DD is not working. I did switch the cable's polarity and made it sound worse so I...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.The ZS6 I fixed up last night now has less bass in the broken and now fixed side. The BA drivers were the only ones that broke off...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.It either flew under most people's radar or people ignored it because it was all BA.
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.KZ ZS10 Pros fit the bill. V-shaped frequency response and some oomph to the bass and crispy treble on the top end, but not peaky like...
-
n0de5 reacted to B9Scrambler's post in the thread Knowledge Zenith (KZ) impressions thread with Like.More DQ6 eye candy, because why not? Also, BA10 kicks @$$. Glad to see some are finally starting to look past the boxy shell and...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.After listening for a bit, my ZS6's are kinda peaky in the highs, and both sides exhibit this so its not because a botched solder job...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.Yay i fixed it! I have a new appreciation for people who work in factories soldering small wires and stuff its really hard. The ZS6...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.Resoldering time. Now its just a matter of which wire to solder on. Edit: I've found that the red enamel coated copper wires are the...
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.I got these for 25. Commencing surgery right now.
-
n0de5 replied to the thread Knowledge Zenith (KZ) impressions thread.Thanks. Anyway is there a way to resolder the wires back on?