no, it doesn't really.

I'd prefer not to wrap them around my ears as that's uncomfortable to me.

i have the 209 now and it is a warm smooth sounding chip even with the ety's. i have not really burned it in yet though.

the one i have is the yellow rosewill one from newegg.   and how do you check a wrist strap without the tool?   will hold the face plate of an amp work just as well as the strap?

and is this accurate?   Pros: Probably does what it's supposed to; none of my parts are fried... Cons: Uncomfortable Other Thoughts: A frequent complaint here and elsewhere is that many of the units appear to be duds from the factory with non-continuity (that is, a break somewhere in...

I just realized that my rosewill POS one doesn't work. Any of you know of some that are guaranteed to work?   and is there any way to test one with stuff lying around the house?

they sound fine. great actually. i  can't really tell though since the first time i used them was that time.   when i changed out the filters (i did so because my wax was soggy and i think it had already clogged them as they sound "bigger" now) the sound got much better. but it could have...

burn them in first

well, i just got my er4-p and just had to used them right after i got done showering. i tried drying my ears out first with a rag, but apparently that didn't get all the moisture out.   how bad was this for my er4?

i'm looking to make a cross feed or buy one for cheap. i have one but i built it rather shoddily and it takes up too much space.

take a look at decware. the DNA horns are the smallest full range horns on the planet. flat down to 20hz.

i prefer USA made and right now my interests are:   project sunrise   the leckerton UHA-6     i have a pa2v2 so i don't really NEED a portable amp (although i will gladly consider them). I think i will be getting an HRT music streamer II for my source. and maybe a sansa clip+ or...

seems like the people that go westone seem to like them more.

have you contacted ety about it? there may have been a problem with the molding process? i'm going to be using westone since they seem to have the only dealers near me.

right now i'm looking at the   LM6171   AD843   OPA227   OPA132   OPA209   what can y'all tell me about the way these op amps sound?