Recent content by mattmatt
  1. mattmatt

    Home-Made IEMs

    Probably was too busy with other stuff when those were created. LOL.
  2. mattmatt

    Home-Made IEMs

    Switching over crossover points and sorts like that. I created something back then with 4 tunings in 1 IEM. Can't actually remember. It was a special project for someone. It can be switched to a single BA, to Dual BA and Triple BA and an alternate tuning for the triple setup iirc.
  3. mattmatt

    Home-Made IEMs

    When off, current flows thru a resistor and when on, it's connected parallel to the resistor so it bypasses it.
  4. mattmatt

    Home-Made IEMs

    The precision from the consumer printers are really great for their price. I've seen OG photons, elegoo mars being used. Phrozen brand is also being used by some manufacturers. I forgot the manufacturer who posted their farm but i've seen these printers on their work table.
  5. mattmatt

    Home-Made IEMs

    Messaged you about airbrushing! :)
  6. mattmatt

    Home-Made IEMs

    Plop the tube flat around the hole then apply adhesive. Make sure you use industrial grade adhesives tho. that's what I do with them.
  7. mattmatt

    Home-Made IEMs

    Just use up all the left resin as is. Use it as adhesive for the faceplate, drivers, etc.
  8. mattmatt

    Home-Made IEMs

    you can reduce your lift height by 2 or 3mm. but with your orientation I think 2mm would be okay. You can use .05 layer height but try increasing your exposure time by 1 second. Don't mind the "finger print" problem you told me. You can always just sand it down and lacquer or buff em out.
  9. mattmatt

    Home-Made IEMs

    You mean you lift your shell 10mm from base? that's way too high in my opinion. I lift mine at 3mm. I think most of those parameters are well built to be configured and it helps with the print. Can you show us how you layout your shells in your software?
  10. mattmatt

    Home-Made IEMs

    that's a bummer to hear. :( great idea, terrible implementation I guess. Someone should try and cook a crossoverless design here. :D
  11. mattmatt

    Home-Made IEMs

    So this means that SWFK 31736 and E50DT0005 has almost the same extension but the SWFK has better 7k response right? In your opinion, which is the better driver when being paired with other systems? Which one behaves more predictable when implemented with other drivers? To me, basing on graphs...
  12. mattmatt

    Home-Made IEMs

    You can use the one I made in page 883. :) There's a link to a thingiverse model.
  13. mattmatt

    Home-Made IEMs

    I think because it's typed in 1000uf :D
  14. mattmatt

    Home-Made IEMs

    A friend told me that SureHold doesn't cure without removing oxygen. It cures with an inhibition layer.
  15. mattmatt

    Home-Made IEMs

    No STL for this. Pretty sure this were molded from this pair of DIY shells.
Top