Hi, I try to make a cow but not really like

Hello all, just share my new one, the shell is quite good wity color spread natural but the face plate is quite fail, : ), really dificult to make a unique face plate.

Hello all, I recieve IEC711 today, could you please share which software use to measure respond curve?

This is my super rotate tool, haha, almost component from my daughter toy, haha

No brand, just cheap UV resin

Hello all, I finish a green one. I will try to make all color. So excited : )

Hi all, I would like to share which I reshell for my friend, I use gear for nail, next time I will make with gear in watch, may be will pay more money. Haha : )

The faceplate really nice, but the shell transparent look not good in this one because inside look quite jumble. Thanks for sharing. : )

My fish is bigger than itsfit , so difficult to put it in face plate

Just place a fish in face plate, bro.: )

Melt solder on solder tip, deep wire in it

Hi all, this is my first ciem, I build with 3D koi fish. The lacquer look better than previous one, indeed must sand shell stritcly to get smooth surface after lacquer. Do you all have experience with black color? I mix with uv glue. But after UV, its still not dry completely inside although...

Thanks for your tip. I will try on my first custom.

Nail UV, 36W, actually black ink I used is not really good, it is not loose like water, it is same toothpaste, so I think it make long time for cure.

Thanks, I used p500, you mean 2 times lack 3 and cure in 1 time, right? Because lack 3 can not smooth if we apply on surface polished.