Do you have a link to the drivers? Cheers!

I find it's great for all use cases except on a plane. It lacks the isolation required to block out all the engine noise. So if you don't travel on planes a whole lot then the passive isolation should be good enough.

Why not just watch the concert on the DAP?

Thanks all! @Kyonnie which epoxy resin do you use and how do you dispense it in very small amounts? I've used superglue with limited success - the flow from the tube is very quick and it seems to dry even faster than it flows, leaving a big mess!

Thanks mate. This is very helpful. For some reason the links don't seem to be working - it just lands at the Ali Express home page? Also do the sockets need to be glued in? If so, what is the best glue to use?

I just lay them flat across a (long) table. But I agree, your method is good!

Anyone know of 14.8mm shells that come with MMCX connectors, but have the leads already soldered? Plenty of 15.4mm ones around the place but I cannot find any 14.8mm shells with pre-soldered leads!

I've not found this to be the case with SMABAT - I've ranked 17 sets of earbuds now and whilst they aren't the best, they are far from the worst. (Just in defense of SMABAT here as I feel they do a lot to push the boundaries for earbud fans!). They probably are tuned for different tastes. Lun...

Anyone have a link to the Hiegi foams?

I've been using gel pads on some other cans but haven't found any that fit the T60RP yet. They are really good for longer listening sessions.

Yes I've done a re-pair and re-boot and it is now working so thanks guys. Just using the sleep mode from now on!!

@FiiO any assistance here please?

Simple! Any tuning paper / damping materials or do you prefer to use these drivers without it?

Excellent. Sorry I think the recommended driver link is broken. Do you have the Russian link?

Thanks mate - do you buy the 20mm or 40mm pre-soldered sockets? Also, what sort of glue do you use?