-
-
kakaworu replied to the thread Grado Fan Club! .Hello Grado friends, I have a set of Grado SR125 and the foam cushion of it melted twice even though I rarely use them. So I made a pair...
-
kakaworu reacted to ejacobsen's post in the thread Fully 3D printed closed-back headphone for 50mm drivers with Like.Extraordinary work! Thank you for sharing.
-
kakaworu reacted to furyossa's post in the thread Fully 3D printed closed-back headphone for 50mm drivers with Like.I hope to see another interesting DIY project soon :beerchug:
-
kakaworu replied to the thread Fully 3D printed closed-back headphone for 50mm drivers.At the request of a friend from a 3D print filament manufacturer, I started working on this project again since last month. We're going...
-
kakaworu replied to the thread DIY Earbuds.When I bought the TRN BT20s Pro for my earbuds. I found that they can't fit my ears when plugging with my stemless earbuds. So I draw...
-
kakaworu replied to the thread Earbuds Round-Up.https://item.taobao.com/item.htm?spm=a1z09.2.0.0.17992e8djPP8dq&id=618283032373&_u=41ij4e8p21b8 This guy sells both drivers and...
-
kakaworu replied to the thread Earbuds Round-Up.130ohm Beryllium is awesome in wood shells.
-
kakaworu replied to the thread Earbuds Round-Up.I have a measurement rig with 3D printed adapter for earbuds. It may not be the most accurate but it measures quite consistently.
-
kakaworu replied to the thread Earbuds Round-Up.I have these 300ohm drivers from QIGOM official store on Taobao. I guess they are the same ones in S300. DIY built a short-stem MX500...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…