Problem solved…nice to have professional solderers at my disposal

Hi b0bb, is there a reason you opted for the SMT diode versus the thruhole? I purchased the one you linked but it’s too small for the pads. Looks like there's enough room for one. If so, would this work as I have a few on hand...

Great news! I am back up and running! Thanks @b0bb ! Going to tackle the supercap next :) How did you actually mounts yours? I see nylon hardware in your photo but there aren't any screw hole openings on the PCB

In the event that I get my Kitsune SU-2 up and running, I think I may take a stab at the supercap mod. Basically putting this assembly in between the output of the power supply and the main board, correct @b0bb? Also, the Belleson SPX installed on the power supply. Would you happen to have a...

@b0bb thanks as always.... So this is what happens when a sales guy (me) plays engineer!. I marked my drawing correctly, all the stars were the negative side. My rework instruction I wrote to the engineer, told him the stars were positive...... UGH! guess I will have to have them measured to...

@b0bb I ran into a problem......did the mods and now the SU2 doesn't power on. With the cover off I can see the LED lit on the power supply board but no lights on the front panel. Had a highly skilled solderer at the facility perform the mods, any suggestions as to where to start to...

Ah, that explains it....I just had the unit on the shop bench. USB was not connected. That's why there was no reading

Thanks again @b0bb. I measured the 3 earlier in the day, they read around .1ma DC across, not 3.3V. Just measured them again and it's the same, barely any voltage reading. Should I leave all the caps as-is then? I am planning to have the rework done on Monday to swap to the IL711S and TPS7A20...

@b0bb , I metered out all the caps. I accomplished this by taking a probe to case of the crystal and checking both sides of the caps you pointed out to replace The ones I circled in yellow did not have a polarity, do you recall that to be the same? Is it safe to say orientation does not matter...

Thanks so much @b0bb . Glad I asked asked as Audiophonics stated to put a cap in all three locations. One other novice question. I purchased the polarized replacement 47uf caps that you suggested. What would be the easiest way to discern which side is positve/negative on the existing...

Thanks Bob, I received these today. The board didn't come with any instructions on mounting the resistors. Can you tell me if my assumption is correct on the attached images please?

@b0bb , found the IL711S in my desk today, totally forgot about this post! Thought to check to see if those TI TPS7A20 were in stock which they weren't back in 2021 when you posted this. They are..... So I think I will do this mod and the Crysteks as suggested on my Kitsune SU-2. I don't...

I do....still LOVING mine!

Apologies.....it's been sold

Dual Faceplate for Sonore / Uptone Audio Excellent condition