Just auditioning my first decent headphones. Audeze LCD-1 Sennheiser HD6XX Grado SR80 Hifiman 560 v4 From the perpective of Phone --> Dragonfly Red vs. Phone --> Dragonfly Red --> Magni... ALL of them sound better with the Magni. Is more power always good? YAY, POWER.

Hi, I'm a newbie and I'd like to know if Sonata HD Pro can totally drive these IEMs: Etymotic ER2SE Impedance : 15 ohms Sensitivity : 96 dB/mW Tin Hifi T2 Plus Sensitivity : 104 ± 3dB @1 kHzV 0.126V dB/mW Impedance : 32 ohms Note: I'd like to listen to classical music. THANKS! :relaxed:

Hi, new poster on this site :). Recently acquired some Dt770 pro 80 when my ath m50x headband broke. initially i was dissapointed by sound and was aware that an amp might resolve the issue. Before purchasing an amp i tried an amp from an old set of (not very good) bookshelf speakers my dad had...

Hello comunity i wanted to know if anyone had tried the DT990 80 Ohms, they are kinda new i think because i had read a lot about the DT770s, DT880s and DT990s variants and i cant find a single thread that talks about the DT990 80Ohms, does somebody has them? In Amazon i saw the 80Ohms and the...

I bought a new phone, the Xiaomi mi a1, and it has a built-in amp with 10V. I also have the Sennheiser IE80, with an impedance of 16 Ohm. The problem is that whenever I use those two with each other, a very annoying hizzing/static noise is to hear. The same with other headphones with low...

Hello guys. I was working with a DIY earbud using drivers from my old KZ ZS3. It was fine at first, but not sure why, one of the driver suddenly doesn't produce any sound. I have checked the connection on each end, and tested the cable with different drivers and it's working properly. But when...

I have a small dilemma. I will most likely be purchasing a Focusrite Saffire 6 soon in order to have an interface that I can track guitars and MIDI into from my desk at university. However I read some calculations that suggest a MAXIMUM of 240 Ohm cans for this amp. If I was to purchase the 32...