Recent content by MisterX
-
How do I solder 2.5mm jack?
Yup, needed some flux for better penetration. ;)- MisterX
- Post #7
- Forum: DIY (Do-It-Yourself) Discussions
-
How do I solder 2.5mm jack?
Put it in a panavise, hit the little step (to the right of the threads in the picture) with flux, tin it , tin the wire, hit it with the flux again and solder on the wire.- MisterX
- Post #2
- Forum: DIY (Do-It-Yourself) Discussions
-
Need Some CNC work
I think a laser engraver may be a better way to tackle that. Google spit out a few interesting hits when I searched for south Florida laser engraving.- MisterX
- Post #5
- Forum: DIY (Do-It-Yourself) Discussions
-
Need Some CNC work
You would prolly have better luck at a trophy shop. Could go the DIY case badge route with it. (print the image on photo paper, cut out, cover with epoxy, finish edges, stick on with double sided tape)- MisterX
- Post #3
- Forum: DIY (Do-It-Yourself) Discussions
-
Trying to replace 3.5mm connector. Do you know which electrical component to buy?
No. Is a panel mount jack going to fit in there? For example Mouser # 490-SJ5-43502PM- MisterX
- Post #6
- Forum: DIY (Do-It-Yourself) Discussions
-
Where are all of the builders?
Absolutely. But in a twisted sense. I don't care if somebody said some boutique parts are not going to help performance.... I'm doing it anyways.- MisterX
- Post #66
- Forum: DIY (Do-It-Yourself) Discussions
-
AMB Sigma 78 and Sigma 79
Has anybody noticed the new boards from AMB Labs? http://www.amb.org/audio/sigma78_sigma79/ Cool stuff. :)- MisterX
- Thread
- Replies: 2
- Forum: DIY (Do-It-Yourself) Discussions
-
Need some pointers for my first amp build
So umm, something along the lines of the Butte? http://www.pmillett.com/butte.htm Boards can be found on eBay... http://www.ebay.com/itm/161919004080 Enclosures as well.- MisterX
- Post #76
- Forum: DIY (Do-It-Yourself) Discussions
-
Widened Jack connector in MP3 Player?
Pop it apart and re-solder the leads on the headphone jack.- MisterX
- Post #2
- Forum: DIY (Do-It-Yourself) Discussions
-
Baffling Hum Issue
Fix the grounding. Detailed troubleshooting without a schematic and photos is nearly impossible and typically = a headache for the readers.- MisterX
- Post #2
- Forum: DIY (Do-It-Yourself) Discussions
-
Li-ion charging
Charge pump? Example: http://www.linear.com/product/LTC1751- MisterX
- Post #6
- Forum: DIY (Do-It-Yourself) Discussions
-
AMB Gamma-2 repair needed
Falling off loose or can shove it over loose? Either way will straighten it out. Shoot me a message and I will let you know where to send it.- MisterX
- Post #2
- Forum: DIY (Do-It-Yourself) Discussions
-
115V to 230V
Depends if the mains transformer primary windings can can be re-wired or not.- MisterX
- Post #2
- Forum: DIY (Do-It-Yourself) Discussions
-
Need some pointers for my first amp build
Killed it by connecting it to a 9 volt battery without a current limiting resistor. ;)- MisterX
- Post #72
- Forum: DIY (Do-It-Yourself) Discussions