Recent content by IKE60
-
FiiO E17 "ALPEN" - First Impression + Final Thought
LOD is analog. The E17 always shows something up in that section of the display, even when operating as only an amp (AUX input). Any quality difference between 3.5mm HP jack and LOD connector will be due to the difference in amping between the two ports on the ipod. The LOD is preferred, but is...- IKE60
- Post #4,284
- Forum: Portable Headphone Amps
-
Sennheiser HD 598 Impressions Thread
I love the E17. It's best, of course, with USB input from my PC, but I use it regularly with AUX input from my iPad or Samsung Galaxy Nexus. Couldn't recommend it more highly for the 3 Ps (price, performance, and portability).- IKE60
- Post #1,562
- Forum: Headphones (full-size)
-
Songs that make your headphone WOOOOOW!!!
+1 Not only is this recording sublime on my HD-598s, but the beginning of the first track is a great test of an audio setup. It allows me to tell the difference between using my E17 as a DAC/amp vs. just an amp. Using the E17 DAC, the cello has such a full, deep, and breathy bass, and I can... -
FiiO E17 "ALPEN" - First Impression + Final Thought
My intent was portability, and as Xeroian said, a powered hub tethers you to an electrical outlet. I wish I had known about the Matrix USB DDC, but I already sank $50 into this setup.- IKE60
- Post #4,162
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
DISCLAIMER: do this at your own risk. I'm not responsible. If you can't get a really small set of tweezers in there, this is what I would try: Put the tiniest dot of superglue on the broken end of the connector, push it into the E17, wait 30 seconds or so, and pull it out. You will definitely...- IKE60
- Post #3,965
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
The issue with the CCK & E17 is that the iPad disables the CCK when it senses the high current draw. I don't know the details of the E17's schematics/design, but methinks the 150mA being drawn is on the +5V line, not the data line. He could test this by turning USB Charging off - then the...- IKE60
- Post #3,923
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
USB should be bit-perfect, regardless of power levels. The power required for a solid signal across a few feet of cable via USB is really small. If a USB port has power issues, it would be noticed on the +5V wire used for powering devices, not on the data line. Even if your port isn't giving the...- IKE60
- Post #3,919
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
This doesn't make any sense. The iPad CCK goes from 30-pin dock connector male to USB A female. The L10 goes from 30-pin dock connector male to 3.5mm male. The two are incompatible. The L10 gets you lineout, but not digital.- IKE60
- Post #3,903
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
Xeroian, Does the Matrix device require the iPad output to be 24b/96kHz, or is that just the maximum supported? I primarily listen to 16b/44.1kHz. Thx.- IKE60
- Post #3,860
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
Does FiiO know something the rest of us don't? Current Android builds (4.0.x) don't allow USB digital audio out. It would be great if Google has actually decided to implement this.- IKE60
- Post #3,842
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
[=http://www.head-fi.org/t/587912/fiio-e17-alpen-first-impression-final-thought/3495#post_8399026]This[/] is how I did it, but it actually cost no less than the Matrix solution. The iPad current limit for the USB CCK is 20 mA. The E17 draws 150 mA (according to a FiiO employee who occasionally...- IKE60
- Post #3,826
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
I've used my Shure SE215 IEMs with the E-17 with no problem, but they are 20 Ω. Per FiiO website, E17 headphone range is 16 Ω to 300 Ω, and at 16 Ω, power output is 250mW. Per Audio-Technica website, ATH-CKS77 are 14 Ω with max power input of 100 mW. Looks to me like you should NOT drive your...- IKE60
- Post #3,729
- Forum: Portable Headphone Amps
-
FiiO E17 "ALPEN" - First Impression + Final Thought
Quote: I am only asking because you did not mention it in your first post, but have you tried the reset button? I've had my E17 for a month now. Yesterday, it would not turn on (regardless of power source). I hit the reset button, and everything is good now. I suggest plugging...- IKE60
- Post #3,679
- Forum: Portable Headphone Amps
-
THE DIY HEADPHONE STAND THREAD
Brilliant. The only thing I can say is that if it were a 16th note, you'd have cable management ;)- IKE60
- Post #1,162
- Forum: DIY (Do-It-Yourself) Discussions
-
FiiO E17 "ALPEN" - First Impression + Final Thought
You're right. I fixed the sampling rate / bit rate confusion in my above post.- IKE60
- Post #3,649
- Forum: Portable Headphone Amps