Lol thankfully not yet! Been working a ton and doing some overtime to keep work going. Havn't had much time for hobby things! Lol thankfully not yet! Been working a ton and doing some overtime to keep work going. Havn't had much time for hobby things!

Relaxing tonight with the Astell&Kern AK100, Leckerton UHA 6S.MKII amp, and Westone W40s. And old setup I've had for years, and as HI-FI as I get, but still really enjoy this setup as I work from home. Occasionally I substitute the W40s for Beyerdynamic DT 880s (250 Ohm).

Hmmm, I'll need to take a second look. I didn't touch (I think) any of the caps. I only touched the joints where the MMCX connector wires touch the BAs. I'll maybe try and clean the solder off with some wick and try again. Are they ll wired together? It look like that to me. I wanna make sure...

Hey guys, hoping I can get some help with an issue. I have Westone W40 IEMs, and my left IEM cracked open and when it did, one of the wires broke from the solder joint. So now I've replaced the wires with 30AWG enameled copper wire. However, in testing it sounds different then the right side. It...

They're 5+ years old.

Can anyone help guide me? I realize this is a DIY earbuds thread and think this fits. I have Westone W40 IEMs. The shell on the left ear cracked open. Then that happened, one of the wires broke. I'm in the midst of trying to repair them. I replaced the ground and signal wire with enameled...

Has any one repaired the W40s? This ear piece cracked open and when that happened one wire from the female MMCX connector broke, so I've replaced both with enameled copper wire (30AWG). Problem now is I think I may be missing a jumper wire or something because I'm not getting sound out of the...

Today's rig while working from home. Because...why not?? 1st Gen iPod classic, Leckerton UHA-6S.MKII amp, and Beyerdynamic DT 880s (250ohm)

Hey guys, looking for help. I've done an SD Card swap for a 3rd gen iPod classic. But somewhere, I found a thread or maybe a post online, where someone had replaced the red LEDs in the 3rd Gen iPod classic, to have colored LEDs for a cool colored look. Does anyone know where I can find any...

Bump, Looking for some quick info. Thanks!!

Hey guys, I'm looking for a clear guide on where to solder with a 4th Gen iPod. I know the output "Z" capacitors/Resistors need to be removed near the DAC, Tha much is clear enough for me. What I'm looking for is where does the other end get soldered to? I'm trying to set this up with a...

Anyone seen thi issue before? iPod 5.5G appears to be charging, but is not actually charging? I installed a new battery thinking it was a battery issue, and same problem. Anyone know where to go?

Hey guys, i'm finally making my way in here as I've finally picked up a nice soldering station (Hakko FX-888). I've repaired a few of my broken headphones I had lying around and would really like to start making new cables, LODs and interconnectors for my DAPs and Amps. As far as the...

Yup sounds about right. Replace the HDD with a Tarken adapter and a new battery and you'll be in business. The taken adapter will allow you to put in an SD card or micro SDXC, depending on which adapter you go with. I'm currently using a single 256GB SD card since that's enough for me at the...

That's pretty awesome. I eventually plan to do the same but at the moment, my 256GB SD card isn't quite full so no need currently.