Head-Fi.org › nikongod's profile
nikongod's Community Profile
|Forum Post Count:
||9 hours, 14 minutes ago
||i like to go hiking, climbing, and listen to headphones. i also like diy a LOT.
|What I do for a living:
||i am a lowley employee of a retail store.
RS-1, RS-60, SR-60, SR-325 (black), HP-2, Head-Fi HF-2
MDR-F1, MDR-CD900ST, MDR-E888SP, MDR-R10
HD-414, HD-650 HD-800
Gone but not forgotten:
Grado 125, 225, rs2, ms-pro, ms2
DT880/250 PRO, DT-250/80, DT770/600
Senn Hd595/120, hd580, like 3 pair of hd650
AKG: k340 (twice) k240sextet (I owned them before people were all about naming them... IDK) K701 on extended loan
2 or 3 Lambdas (who can keep track of which versions) Omega 2, SR40
Ultrastone - hfi-780
|Headphone Amp Inventory
SHA-1 (out of commission)
Wolrd Audio Design:
The Silver Ghost an OTL balanced amp.
"The small transformer coupled amplifier with 1 tube that did not come out quite as hammer-toned as I would have liked"
The cage match.
Balanced mahogany Cmoy with JRC4556 op-amps.
"The 2X4" a DIY miodified 2X4W push-pull amplifier set up for dynamic or electrostatic headphones.
Technics SL-1015 with EPA-500 arm
DIY opamp based phono-stage with single stage passive RIAA & 0ohm input impedance :)
Esound E5 with a couple mods
Behringer SRC2496 & DEQ2496
||I make cables with some clear tape, and some not so clear tape.
||monster power conditioner
nikongod's Recent Activity
Headphone amp with speaker output
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/16/13 at 7:04pm | 6 replies | 58 views
Valve amp modification/design on a budget. Advice requested...
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/13/13 at 7:59pm | 10 replies | 211 views
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/12/13 at 5:50am | 40 replies | 764 views
Will resistors in series hurt signal quality in iems?
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/8/13 at 10:50am | 2 replies | 56 views
Post Your Photography Here #2 (new dial-up 800X600 friendly)
nikongod posted in this thread in Members' Lounge (General Discussion) 5/6/13 at 7:18pm | 10685 replies | 461602 views
Are there any headphones / mods that let you switch between closed and open backed?
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/6/13 at 6:20pm | 3 replies | 109 views
Suggestions for recabling for high (RF) noise enviroments (that will sound good and not break the bank)
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/6/13 at 8:56am | 7 replies | 74 views
Eddie Current DIY amplifier "Monolith"
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/6/13 at 8:20am | 58 replies | 1925 views
Eddie Current Zana Deux voltage step down from 120V to 100V?
nikongod posted in this thread in DIY (Do-It-Yourself) Discussions 5/3/13 at 8:40am | 5 replies | 126 views
3 albumsView All Photos
nikongod’s Embedded Photos
5 albumsView All Photos
Latest upload: Apr 22, 2013
Latest upload: Mar 5, 2013
Latest upload: Jun 4, 2012
Latest upload: Dec 13, 2011
Latest upload: Dec 29, 2011
nikongod's Forum Signature
Originally Posted by nikongod:
The Fail is strong with this one