Post pics of your builds.... - Page 140

I ordered from them several times, they are usually very prompt (shipped to the States in approximately one week or less) -- one exception is during Chinese New Year and that's completely understandable.

I was just comparing it to shipping inside the US. C'mon, guys.

excellent looking amp, glad to see im not the only crazy using 4 pin connectors for balanced headphones (besides the K1k obviously)

Thanks! Yeah, I don't believe in following poor standards just because they're the norm *cough*3-pin XLR*cough*. 4-pin XLR makes much more sense.

Here is my finished (for now) Millet Maxed Hybrid.

Beautiful casing, the whole thing is beautiful!

Thank you. That picture is my lame attempt at HDR. Here are some more pics.

Where is that case from?

It's a stock Hammond that I made some cherry ends for. I wish I bought a black case so I could have used some darker wood. I made some lacewood pieces but they seemed a bit to dark for the silver case.

The second set of pictures look much better.

Nice job on the case!

Yeah that's what happens when you let Photoshop do it's own thing.

Motorcycle amp/cellphone/gps interface

Finally completed my motorcycle helmet amp thing
basic function
amp is sijosae ab 3 channel my current favorite.
tread type regulator with spst relay input protection need to keep as much voltage as possible.
5v regulator to charge phone ipod etc diode protection
3.5 mm input for ipod
2.5 mm jack for cell phone vox circuit overrides ipod through dpdt relay with 15 second delay
3.5 mm switched jack for gps pluging in disconnects 2.5 cell phone input. did not relay this takes to much space
used 6 pin cb connector 1 straight at amp 1 angle at helmet for cable
bare circuit board

all hooked up



the helmet Nolen n100e had a j&m intercom before i got it

Ksc75 Kramer modded sounds real good. area behind and around drivers is open on this helmet its made for intercom units

Custom 2.5 mm jack with nextel ptt

Helmet cable

thats awesome, nice build!

Very nice build heatmizer, great way to pull it all together to solve a very custom problem.

A new M3 is born today! I started on this project about 2 weeks ago for school because my school lets me get out 2 weeks early for senior project so I decided to build an M3 and a STEPS. I was also required to choose a mentor for this project and I chose NeilR, who I would definitely not have finished this project without Neil's help. So Neil, I owe you a great deal of thanks in helping me on this project. This thing sounds amazing!