Head-Fi.org › Forums › Equipment Forums › Headphones (full-size) › Shirt Clip for canalphones...
New Posts  All Forums:Forum Nav:

Shirt Clip for canalphones...

post #1 of 8
7/20/04 at 11:04pm
Thread Starter 
Any Suggestions on where I can find a small shirt clip
I can use for my Shures (E2 or E5's).

Need something cause they move about behind my neck and snag
on my safety vest.
Reply
post #2 of 8
7/21/04 at 2:59am
If you think the ety shirt clip would work Todd has them for like $8 iirc. I haven't seen ety and shure cords side by side so I'm not sure if this would work.
Reply
post #3 of 8
7/21/04 at 3:46am
You could try a paper clip and a little piece of adhesive tape. Bind the cable to the clip with the tape and BAM! - ten bucks saved! Also very stylish.
Reply
post #4 of 8
7/21/04 at 3:56am
Eventually that is going to cost you ten dollars in tape, though if you use a Karma the paper clip might come in handy.
Reply
post #5 of 8
7/21/04 at 7:15am
I attach the cord on my e3c's to the back of my t-shirt using a 15 pence small buldog clip from the supermarket works a treat

ian
Reply
post #6 of 8
7/21/04 at 2:24pm
I use a hairpin. If you don't know anyone who uses them you can buy a batch for a dollar. Just slide the straight end down the little plastic tube that adjusts the cable lengths and clip it to the back of your collar.
Reply
post #7 of 8
7/21/04 at 3:34pm
The smallest, best clip that I've found is the one that comes with the Ety-com.
Reply
post #8 of 8
7/21/04 at 8:43pm
Thread Starter 

ETY Clip...

The smallest, best clip that I've found is the one that comes with the Ety-com.
==========

Will that work for the Shures?
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Headphones (full-size)
Head-Fi.org › Forums › Equipment Forums › Headphones (full-size) › Shirt Clip for canalphones...