I just recently acquired a pair of Sony MRD-10RNC and its missing the Positive and Negative leads for the noise canceling. I was just wondering if someone could maybe take a pic of the board inside for me so I know where to solder some new leads onto the board and get them working properly. I tried searching but couldn't find anything
Edit: I ended up finding where the positive lead goes for the battery now I just need to figure out where to solder the ground wire. I cant just solder it to any ground or neutral cause ill get interference out of the left or right speaker. Again a pic would be great and very helpful or I guess I can just start trying out different grounds until I get it lol
I have tried out different grounds and still cant find out exactly where it needs to go. when I turn the noise canceling on I get a faint hum out of the right side and the music at that point sounds distorted badly and just all around horrible. when I turn the noise canceling switch off and both the left and right side sound normal like they should.
if anyone can provide me with a picture of where the leads are soldered to from the battery compartment that would be much appreciated.