post #1 of 1
Thread Starter 

Hello,

 

   I just recently acquired a pair of Sony MRD-10RNC and its missing the Positive and Negative leads for the noise canceling.   I was just wondering if someone could maybe take a pic of the board inside for me so I know where to solder some new leads onto the board and get them working properly.  I tried searching but couldn't find anything

 

 

Edit: I ended up finding where the positive lead goes for the battery now I just need to figure out where to solder the ground wire. I cant just solder it to any ground or neutral cause ill get interference out of the left or right speaker.  Again a pic would be great and very helpful or I guess I can just start trying out different grounds until I get it lol

 

                                                                        Thank you very much in advanced :)