Head-Fi.org › Forums › Equipment Forums › Computer Audio › RME Digi96/8 Pad: any problems passing a Dolby Digital / DTS signal to an AV receiver
New Posts  All Forums:Forum Nav:

RME Digi96/8 Pad: any problems passing a Dolby Digital / DTS signal to an AV receiver

post #1 of 9
Thread Starter 
Does the RME Digi96/8 PAD have any problems passing a Dolby Digital or DTS signal via either optical or coaxial digital output to an AV receiver (Outlaw 1050)?
post #2 of 9
No.
post #3 of 9
Quote:
Originally Posted by Iron_Dreamer
No.
Are you sure?
post #4 of 9
It is the one downfall of the E-MU cards... the S/PDIF support is only 2 channel and they cannot pass a DTS/DD signal... <we need an annoyed emoticon>
post #5 of 9
I am using tosslink, and no.
post #6 of 9
This is confusing. Is it

No - there are no problems? or
No - it doesn't work?
post #7 of 9
Quote:
Originally Posted by mshan
Does the RME Digi96/8 PAD have any problems passing a Dolby Digital or DTS signal via either optical or coaxial digital output to an AV receiver (Outlaw 1050)?
I believe the "NO" was the answer for that question.
post #8 of 9
I'm sure it would pass the singal just fine if it was a DTS/AC3-wave set to the PCM format ID sent to the card with ASIO or Kernel Streaming.
post #9 of 9
no....



New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Computer Audio
Head-Fi.org › Forums › Equipment Forums › Computer Audio › RME Digi96/8 Pad: any problems passing a Dolby Digital / DTS signal to an AV receiver