Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Shure SRH940 and Beats Pro Potential Driver Swap
New Posts  All Forums:Forum Nav:

Shure SRH940 and Beats Pro Potential Driver Swap - Page 2

post #16 of 42
Well whatever you do, don't use a bad screwdriver to unscrew the hinges. I accidentally stripped the screws, then I had to rewire it outside of the hinge.

 

 

 

post #17 of 42
Thread Starter 
T-4 is it?
post #18 of 42
Quote:
Originally Posted by Squeeesh View Post

T-4 is it?
 

Yeah it is.

 

The big one in the middle was a crosshead. Was!


Edited by vantt1 - 6/3/14 at 5:27am
post #19 of 42
Thread Starter 
I can't get any of them to budge. I think I'm just going to go back to a two wire set up…
post #20 of 42
Quote:
Originally Posted by Squeeesh View Post

I can't get any of them to budge. I think I'm just going to go back to a two wire set up…

That's a shame

post #21 of 42

Why not just thread the wires through? 

post #22 of 42
Quote:
Originally Posted by nikongod View Post
 

Why not just thread the wires through? 

Through what?

post #23 of 42
Quote:
Originally Posted by vantt1 View Post
 

Through what?

 

Through the hinges. 

Isnt that why you wanted to take them apart? 

post #24 of 42
Quote:
Originally Posted by nikongod View Post
 

 

Through the hinges. 

Isnt that why you wanted to take them apart? 

The cable has to go through the hinge, and as you can see from the picture below, it's a pretty sharp turn. The cable's diameter is also too thick to be simply threaded through.

 

post #25 of 42
Thread Starter 
Quote:
Originally Posted by nikongod View Post

Through the hinges. 
Isnt that why you wanted to take them apart? 
That would have just been a benefit. The true purpose is to better them with higher quality drivers. Hopefully the new layout will not botch the audio.
post #26 of 42
Thread Starter 
I'm pretty sure I just conceptualized a method of having a hot swappable driver system that involves Legos. Tomorrow's going to be interesting…
post #27 of 42
Quote:
Originally Posted by Squeeesh View Post

I'm pretty sure I just conceptualized a method of having a hot swappable driver system that involves Legos. Tomorrow's going to be interesting…

Good luck trying to get an airtight seal with Lego...

post #28 of 42
Thread Starter 
I meant for the connector
post #29 of 42
Thread Starter 
But I don't think I'll use it because it would take up too much space
post #30 of 42

I don't think those Lego connectors are audio-grade contacts, either. It'd defeat the purpose if you intend to use Shure drivers.

New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Shure SRH940 and Beats Pro Potential Driver Swap