or Connect
Head-Fi.org › Forums › Equipment Forums › Sound Science › Difference between cheap and expensive DAC
New Posts  All Forums:Forum Nav:

Difference between cheap and expensive DAC - Page 2  

post #16 of 51
Quote:
Originally Posted by spaark View Post

Well, since you said "trust me", I'll take your word for it!

No, this is the Sound Science forum.
Never trust anyone who says "trust me"!
post #17 of 51
Thread Starter 
Quote:
Originally Posted by Beatrice View Post

the difference is huge.trust me. but you need to find the most suitable one for specific headphones
Is't the goal of a DAC to sound as neutral as possible? and that the amp usually is used for colouring the sound? I have never seen a DAC that really colours the sound alot, trust me :P
Edited by dead99 - 1/3/14 at 2:16am
post #18 of 51
Quote:
Originally Posted by dead99 View Post

is't the goal of a DAC to sound as neutral as possible? and that the amp usually is used for colouring the sound? I have never seen a DAC that really colours the sound alot, trust me :P
I've read that all amps sound the same. Except tubes.
I've also read that the biggest difference is between headphones or speakers.
post #19 of 51
Quote:
Originally Posted by krismusic View Post


I've read that all amps sound the same. Except tubes.
I've also read that the biggest difference is between headphones or speakers.

I've read about Pixie dust...

post #20 of 51
Quote:
Originally Posted by dc-k View Post

I've read about Pixie dust...
Fair point!
post #21 of 51
Quote:
Originally Posted by krismusic View Post


Fair point!

this came up in another thread, I enjoyed it and it may be of interest, taken as a guide but not gospel...

 

http://en.goldenears.net/index.php?mid=KB_Columns&document_srl=1921&m=0

post #22 of 51
Interesting link. I gave up with speakers because my room is so hopeless.
I thought it would be easier to get a good sound with headphones.
Then I found Headfi !
post #23 of 51
Thread Starter 
Quote:
Originally Posted by krismusic View Post

I've read that all amps sound the same. Except tubes.
I've also read that the biggest difference is between headphones or speakers.

Yes, that's true but I meant it more in the way that you choose a amp to suite the headphones (and the music you're listening?) and not the DAC.
post #24 of 51

Well, audiophiles don't like to admit it but hi-fi DACs and amps are supposed to sound identical. If they don't, then they add lots of harmonic and intermodulation distortion, roll-off the frequency response, have a high output impedance that may change the frequency response of the headphones etc. But maybe part of the hobby should be relabeled "listening for differences" anyway, because it seems there's a strong urge in some people to hear difference, even if there are none.

 

 

Before spending big bucks on DAC/amp, if at all, I'd make sure to have very, very good headphones (and those still usually need a bit of equalization, which most amps clearly do not).


Edited by xnor - 1/3/14 at 7:34am
post #25 of 51

Here is part of my checklist when looking for DAC:

 

- Linear power supply and at least decent regulation section

 

- Self-powered USB section (which means it works without pin1&pin4 of USB), so that I don't even need to face the possibility of ground-loop or noise issue between DAC and PC. This criteria alone fails a lot candidates, even some expensive ones.

 

- Asynchronous USB section with stable driver and wide format support (24/192 is a must, DXD/DSD are good to have). Yup I don't really have much hi-res files, but this is more of a 'why not' thing than a 'why must' thing to me.

 

- Individual TCXO clocks for multiplies of 44.1khz and 48khz.

 

- Fully balanced with both XLR out and RCA out. (Again, why not?)

 

- Finished commercial product (No DIY, no half-finished products like Buffalo etc. To me the effort to deal with those cost more than the money it may save.)

 

 

 

I didn't have too much choices actually.

post #26 of 51

Sure, you have some "why not" points, but if you gotta pay extra for it you have to ask yourself: why? ;)

 

I don't see self-powering a problem at all. Heck, even some recording audio interfaces are self-powered.

post #27 of 51
Quote:
Originally Posted by xnor View Post
 

Sure, you have some "why not" points, but if you gotta pay extra for it you have to ask yourself: why? ;)

 

But I don't ask :p

post #28 of 51

Things I have come to appreciate about the more expensive audio interfaces are the superb software, increased channel count and extensive routing options.

 

It's great having multiple inputs. Not only are they usually better (mic pres especially) you can have everything connected simultaneaously. Ready for instant use.

 

Likewise having multiple outs. Route audio via BT, or a satellite system, Different audio channels on speakers and headphones. Being able to use sophistacated EQ & effects on any channel.

 

You can buy genuine pro grade gear from the likes of RME, Metric Halo and SPL for less than $1,000. You have almost certainly bought music or listened to broadcasts made on this grade eqipment. It's not worth buying 'better' since you cannot extract what was not there in the first place.

post #29 of 51

For me, we can also expect less jitter and crosstalk from a good audio card.

post #30 of 51

So...once again: the DAC chip architecture plays no importance here?

 

My intuition says that the DAC chip shouldn't play much of a role at all...but then my knowledge of these things is rather limited.

 

Looking for a little sense from the skeptics.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Sound Science
This thread is locked  
Head-Fi.org › Forums › Equipment Forums › Sound Science › Difference between cheap and expensive DAC