or Connect
Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › 2A3 tube amp - Grant Fidelity MS-2a3
New Posts  All Forums:Forum Nav:

2A3 tube amp - Grant Fidelity MS-2a3

post #1 of 3
Thread Starter 
So I am finally dipping my toe in the world of head-fi. After much research and some advice from local head-lebrity Skylab, I picked up a pair of Beyerdymnamic DT990 (250Ω) headphones. I am running them on the headphone output of my beautiful and rare Grant Fidelity MS-2a3 amplifier. The amp provides 14 watts of 2a3 goodness per channel on it's speaker outputs and has plenty of power to drive the Beyers.

I am still learning about impedance matching. My question is this, am I OK running these 250 Ohm headphones on this amp? I have not seen a ton of documentation on the headphone circuitry aside from the line "Tube headphone output on 2A3 circuit" on the Grant Fidelity Product page ( http://www.grantfidelity.com/site/Grant_Fidelity_MS2A3_integrated_tube_amplifier ) I know this amp is based on the Yaqin MS-2a3 integrated, however there are some differences according to the folks at GF when i traded emails with them. I do not know exactly what they are, though I am positive they are upgrades on the Yaqin version. smily_headphones1.gif

And an off shoot question: this amp is made to drive speakers as well as headphones. Do I NEED to have speakers hooked up to this tube amp? I know not to run a tube amp with no load. When i plug into the 1/4 socket, i hear the amps relays click and the blue HEADPHONE light comes on so I know the load is routed properly. Would it damage that amp if I unplugged my headphones from the amp while it was on with no speakers attached?

If I want to swap headphones during a listening session, is it recommended that I power the amp down before making the swap? (I have a pair of AKG K701s on the way.)

thanks for reading. smily_headphones1.gif

-JoeDotCom


Gear porn:
negataqu.jpg
post #2 of 3
Thread Starter 
Anyone else using 2a3 or 300 head amps?
post #3 of 3

Subcribing.

 

I am getting a custom 2A3 integrated amp with a headphone output built for me which is going to arrive in a few weeks.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Headphone Amps (full-size)
Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › 2A3 tube amp - Grant Fidelity MS-2a3