Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › How To Remove Bare Speaker Wire Strips From Within AV Receiver Speaker Terminals
New Posts  All Forums:Forum Nav:

How To Remove Bare Speaker Wire Strips From Within AV Receiver Speaker Terminals

post #1 of 4
Thread Starter 
Hello
 
The speaker wire was poorly terminated. Loose speaker wire strips are within the speaker terminal. 
 
What is the best way to remove all those bare speaker wire strips from within the av receiver's speaker terminal? 
 
The av receiver is the RX-V673.
 
Please see a photos of the av receiver at the following official link: http://usa.yamaha.com/products/audio-visual/av-receivers-amps/rx/rx-v673_black_u/?mode=model
 

The speaker terminals are the Yamaha type that have a knob that can be tightened and loosened. However, the knob doesn´t seems to come off completely. The speaker terminals can receive banana plugs.

 
Thanks.

Edited by forumaudio20 - 8/20/13 at 4:27am
post #2 of 4

I think you posted on the wrong forum.

post #3 of 4
Thread Starter 

please, which forum then?

thanks.

post #4 of 4

Had a look at the video . You have to freeze it quick but while the speaker outputs[main] have sockets for banana plugs if you screw the plastic nuts right back this will allow you to push a probe into the back of the terminal and force out the broken pieces. Most of the space is shrouded to stop the bare wires touching the case but there will be a slot to allow you to push out the broken wires. ---Its also possible that there is a hole that you push the wires through if that is the case then you will have to use a small rounded probe that is capable of going through the small hole. I have come across this type before. 


Edited by duncan1 - 8/20/13 at 1:15pm
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Dedicated Source Components
Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › How To Remove Bare Speaker Wire Strips From Within AV Receiver Speaker Terminals