Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Modding Detachable Cable and Mic for the Audio Technica ATH-M50
New Posts  All Forums:Forum Nav:

Modding Detachable Cable and Mic for the Audio Technica ATH-M50

post #1 of 2
Thread Starter 

Hello, I wanted to mod my M50 to have a detachable cable and microphone.

 

This is how I was thinking to set it up: Two 3 pin/pole 3.5 mm cables into a 4 pin/pole cable that is attached to the headphones, then a removable microphone attached to the headphones too. I want it to work even if i remove the microphone. I will buy a 4 pin to 2 x 3 pin splitter and then remove the 4 pin female connector and attatche an 4 pin male connector. Then i will buy one 3 pin connector for the microphone and use the 4 pin female connector on the headphones.

 

How can I make this work. Thanks in advance :)

post #2 of 2

Did you make any progress with this project? I was thinking of doing the same.

New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Modding Detachable Cable and Mic for the Audio Technica ATH-M50