Head-Fi.org › Forums › Equipment Forums › Headphones (full-size) › Denon AH-7100D rewite to 4-pin Neutrik, Before I cut the plug off..
New Posts  All Forums:Forum Nav:

Denon AH-7100D rewite to 4-pin Neutrik, Before I cut the plug off..

post #1 of 5
1/10/13 at 5:54pm
Thread Starter 

Before I cut the stock 1/4" plug off does it have 4 wires at the terminal end? I know the 7000D did. Are there 2 blacks a red and a white? What's what? both blacks - the red r+ white l+?

Thanks

 

I will be doing this to the non in-line remote/mic cable. 

Reply

Head-Fi's Best Sellers

post #2 of 5
1/10/13 at 7:12pm

Yes it has four wires. I don't remember what colors they are but it's not hard to figure out what is what if you have a multi-meter.

Reply
post #3 of 5
1/11/13 at 7:01am
Thread Starter 

Sounds good, thanks. I'll use my multi meter to check for impedence. Any way to tell which is positive and negative? For full size speakers I use a 9v battery. If the sub pops out the positive on the battery terminal is positive speaker wire, if it sucks in its backwards. I suppose I could try this with a AAA battery w/o damaging the driver...If I can even see the driver move on the 7100 that is.

Reply
post #4 of 5
1/11/13 at 10:38pm

All you have to do is test for continuity since the cable detaches. Tip of the connector at the headphone end is positive so just find the wire that passes a signal when you touch both ends.

 

BTW, I just unscrewed the XLR on mine and the wires are red, white and two blacks. red is R+, white is L+ and you just have to figure out which is which on the blacks.

Reply
post #5 of 5
1/12/13 at 7:34pm
Thread Starter 
Thanks
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Headphones (full-size)

Head-Fi's Best Sellers

Head-Fi.org › Forums › Equipment Forums › Headphones (full-size) › Denon AH-7100D rewite to 4-pin Neutrik, Before I cut the plug off..