New Posts  All Forums:Forum Nav:

For Sale: FS: EHHA 1

post #1 of 6
Thread Starter 
This Classified is Closed

For Sale:
FS: EHHA 1

Will Ship To: USA

I'd like to sell my EHHA 1 (non rev-A) for $300 + shipping. It was originally built by Funch, and it sounds wonderful. It was purchased in January 2010, and has been well-used since then--probably around 1000 hours.

It's configured to use MOSFET's as opposed to BJT's, and uses an s22 for the power supply.

Some pictures are available here: http://www.head-fi.org/t/85561/post-pics-of-your-builds/6150#post_6268661 -- nothing's changed in its condition, but I can send updated pictures to interested buyers.

The original FS thread is here: http://www.head-fi.org/t/469680/sold-ehha-i

I will include all the information I have on it. It still uses the same 6GM8's that came with it. It has a separate heater switch so the tubes don't get stripped. I never did anything to the front panel to fix the hole size of the locking Neutrik jack (you can see some tin foil that Funch stuck in there to make it look better), nor have I made any other modifications to it.

I'd prefer to ship FedEx because I trust them, and for heavy packages are generally cheaper than USPS. I can also ship via USPS if that's what does it for you. I seem to recall it's around 15 lbs to ship, so I would expect shipping to be around $50 (this is how much shipping was when I bought it within the lower 48).

Finally, the general disclaimer: I don't smoke, I have no kids, I don't have any dogs (but really love them), cats, or other pets, and take very good care of things. I've got positive feedback here in the old forum and on my trader feedback page. I reserve the right to not sell to you if you act fishy--PayPal, while the only mutually acceptable option, does not generally favor the buyer in disputes.
 

post #2 of 6

What are the dimensions of the casing for this build? 

post #3 of 6

This is killer deal for someone!

 

Looks like a 12 x 12 x 4 chassi

post #4 of 6
Thread Starter 

Sachu's correct; the enclosure is 12x12x4, except for the front panel which is 12.2"x4.2". The case, in particular, is a Par-Metal 20-12124. The case has rubber feet installed which raise it by around a 1/2".

post #5 of 6

PM sent.

post #6 of 6

PM sent.
 

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Amplification For Sale / Trade