Head-Fi.org › Forums › Equipment Forums › Portable Headphones, Earphones and In-Ear Monitors › My klipsch custom 3 broke (pics)...
New Posts  All Forums:Forum Nav:

My klipsch custom 3 broke (pics)...

post #1 of 4
2/22/12 at 9:26pm
Thread Starter 

I took the tip off after using them and the barrel came with the ear tip mad.gif.  It still can slide back in, it just looks like the glue came out.  Unless something actually did break inside (notice the white part in the third and fourth pics.)...

P2220410.JPG

P2220411.JPG

P2220415.JPG

P2220416.JPG

 

Do you think it can be glued back together?  I don't want to risk the glue getting in and ruining the driver.

 

I thought about using it as an excuse to get customs, but they are expensive and I'm not sure I like these enough to get customs.

Reply
post #2 of 4
2/22/12 at 9:32pm

Just glue it with the base facing down so the glue doesnt drip to the inside. I would put the glue on the piece that came out, super glue etc should try quickly.

Reply
post #3 of 4
5/22/12 at 5:01pm
Thread Starter 

Bumping this again now that I actually have time to fix it.

 

What kind of glue?  there's not much space between the two peices honestly.  I'm afraid using superglue would make a mess.

 

This might make even more of a mess, but what about the stuff used to glue pvc pipes etc.  I know it would never come apart lol.

Reply
post #4 of 4
5/22/12 at 10:00pm
Superglue made by UHU (*not the normal UHU) would be what I consider to be best on this kind of application since it is much less runny than most other brand of superglue. If you can't find UHU superglue, 3M superglue under the Scotch trade mark is a good alternative.
Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Equipment Forums › Portable Headphones, Earphones and In-Ear Monitors › My klipsch custom 3 broke (pics)...