Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › 125i's and Little Dot MK II
New Posts  All Forums:Forum Nav:

125i's and Little Dot MK II

post #1 of 3
1/23/12 at 9:15am
Thread Starter 

Hey im waiting on my Grado 125i's (woody modded) to arrive and was going to order the LD MK II but i read a post saying that they werent a good match and that the MK II was designed for higher impedance cans

 

but only one post on this and no other sources so i dont know if its true

 

i looked at the I+ but i would like the line out for my speaker amp (t-amp)

Reply
post #2 of 3
1/24/12 at 12:13pm

All Little Dot amps I believe are designed for a 32 Ohm load. My 1+ and MarkII both drive my Grado and Ultrasones very well.

 

 

Drew

 

Reply
post #3 of 3
1/24/12 at 4:47pm
Back when I had my ultrasones I was asking about the LD MKV on their forums and I was told for low ohm headphones the I+ is best out of the line up, at least up to the V.
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Headphone Amps (full-size)
Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › 125i's and Little Dot MK II