New Posts  All Forums:Forum Nav:

V-Moda M-80/V-80 Issue

post #1 of 5
1/5/12 at 9:51pm
Thread Starter 

This is bugging me, I received my V-80's today and when I plug in the cable, there is almost always a channel imbalance (the right channel is much softer than the left channel), only until I readjust the cable by turning around I can hear both channels well.
It's frustrating, anyway around this?

Reply
post #2 of 5
1/5/12 at 11:57pm
Thread Starter 

Can anyone help meeeee

Reply
post #3 of 5
1/6/12 at 12:07am

Have you tried both cables?  Same result?

Reply
post #4 of 5
1/7/12 at 11:57pm
Thread Starter 

Yeah, same result...
I'm thinking it's something to do with the female connector???

Reply
post #5 of 5
1/8/12 at 12:18am

Sounds like it could be a tweaked jack?  I'm assuming the sound changes when you fiddle with the headphone side.  Even though it should work with the cables it came with, you could try using another standard 3.5mm to 3.5mm just to see what happens.  But unfortunately it might be something loose inside too.  Maybe try cleaning the plug(s)- perhaps some gunk got inside of the jack.  And sometimes those jacks could get some oxidation going on inside and it might take a few turns and in-and-out cycles to clean the contact points, though this shouldn't be the case with newly manufactured headphones.  I would say if after doing the above it still acts the same, send her back (or try contacting V-Moda).  Where did you get them from?

Reply
New Posts  All Forums:Forum Nav:
  Return Home