or Connect
Head-Fi.org › Forums › Equipment Forums › Portable Headphones, Earphones and In-Ear Monitors › The discovery thread.! New NiceHCK DZ7 1DD+6 BA iem impression by ericp10. Page 2153
New Posts  All Forums:Forum Nav:

The discovery thread.! New NiceHCK DZ7 1DD+6 BA iem impression by ericp10. Page 2153 - Page 353

post #5281 of 32897
Thread Starter 

I think your right. This is the official spec of the Ele dac on ebay.

 

Main technical parameters: compatible the USB 1.0 16bit support 32 KHz / 44.1khz / 48khz sampling Dynamic range: 100dB noise signal ratio: 105db (faith typical values) THD + N: 0.002% Internal integrated independent 12MHz clock generator built-in 8 x Oversampling digital filter Adopt double power supply.Analog part is + 5V , Digital parts for + 3.3 V SSOP- 28 encapsulation The chip adopt the famous PCM2704 , Uses metal film resistor, capacitance, polypropylene capacitor, double panel design, the USB interface provide power supply , output directly meet headphones.

 

This is the Spcs for the Hifimediy Sabre Dac

 

This small and simple dac uses the ES9023 dac chip from Sabre with SABRE DAC technology. It's is a quite new chip that features outstanding audio quality in a simple implementation. The ES9023 dac chip has a driver built in which outputs 2Vrms line level signal,and are able to drive low impedance loads like headphones, but at 32ohm the output power is reduced to 1Vrms, so connecting to an amp/preamp is recommended. The new batch uese the LT1763 low noise regulator. This DAC chip does not have any DC voltage at it's output, eliminating the need of a DC coupling capacitor at the output. With patented HyperstreamTM architecture and Time Domain Jitter Eliminator, the ES9023 delivers jitter-free studio quality audio with 112dB DNR. With this DAC we combined the Sabre DAC chip with the quality Tenor TE7022 USB receiver. It accepts up to 96khz/24bit input signals from USB, and it will upsample lower input signals to feed the ES9023 dac chip with 96/khz/24bit signal. This makes it possible to get a great dynamic range of 112db. (in case a 16 bit receiver like pcm2706 were used it would have been limited to 96dB.) It responds to changes in system volume control (on MAC with volume hotkeys). No drivers required for Windows, Mac and Linux. Output on 3.5mm headphone jack.

 

The output on the Ele looks like it is using some power in the output and it says on there the Hifimediy uses none which would explain the volume difference in the two.

 

Can't seem to use firefox today at headfi for some reason. Whacky.


Edited by Dsnuts - 11/29/12 at 2:05pm
post #5282 of 32897
Quote:
Originally Posted by Dsnuts View Post
Can't seem to use firefox today at headfi for some reason. Whacky.

 

Something happened for me when my firefox was auto-magically updated to version 17 a few days ago. I was going to say that when doing a reply, I wasn't getting the proper editor. But looking now, I see that the proper editor is back. Cool. So whatever that problem was is now gone.

 

I'm pretty sure that head-fi has been doing some upgrading though as well - on my smartphone, the forums now look like they are optimized for the smaller screen (which is nice).

post #5283 of 32897
Thread Starter 

So now I have a good idea how one of these could sound like.

700

I would love to try one just to see how close the Hifimediy comes to this..

post #5284 of 32897

If you'd like to demo mine sometime after Christmas, we could make that happen.

beerchug.gif

~BG

 

Quote:
Originally Posted by Dsnuts View Post

So now I have a good idea how one of these could sound like.

700

I would love to try one just to see how close the Hifimediy comes to this..

post #5285 of 32897
Thread Starter 
Your a great man BG. I might take you up on that. Just to hear the difference. If they end up sounding the same. Wow.
post #5286 of 32897
Thread Starter 

2nd post. Sorry fellas. It has been weird all day.


Edited by Dsnuts - 11/29/12 at 2:30pm
post #5287 of 32897
Thread Starter 

3 post lol!

post #5288 of 32897

Just PM me and we'll set it up.

smily_headphones1.gif

Quote:
Originally Posted by Dsnuts View Post

Your a great man BG. I might take you up on that. Just to hear the difference. If they end up sounding the same. Wow.
post #5289 of 32897

Just my 2 cents on cables. I've had great luck with mediabridge products, and they're even cheaper than the Belkins.


http://www.amazon.com/Mediabridge-Hi-Speed-USB-2-0-Cable/dp/B001MXLD4G/ref=sr_1_1?s=electronics&ie=UTF8&qid=1354231040&sr=1-1&keywords=usb+cable+a+to+b

 

And the 10' is only $5.49

post #5290 of 32897
Quote:
Originally Posted by bjaardker View Post

Just my 2 cents on cables. I've had great luck with mediabridge products, and they're even cheaper than the Belkins.


http://www.amazon.com/Mediabridge-Hi-Speed-USB-2-0-Cable/dp/B001MXLD4G/ref=sr_1_1?s=electronics&ie=UTF8&qid=1354231040&sr=1-1&keywords=usb+cable+a+to+b

 

And the 10' is only $5.49

 

Thanks. But, do you see a difference?

http://www.amazon.ca/Mediabridge-Hi-Speed-USB-Cable-Feet/dp/B009DG1U1U/ref=sr_1_1?ie=UTF8&qid=1354231491&sr=8-1

 

I see a difference... $21.99 CN versus $4.99 US! Gouge on amazon.ca! (or whoever is responsible)

post #5291 of 32897

I'm using this one right now.

http://www.monoprice.com/products/product.asp?c_id=103&cp_id=10303&cs_id=1030301&p_id=5438&seq=1&format=2

 

Here is a list for all different colors and length.

 

http://www.monoprice.com/products/subdepartment.asp?c_id=103&cp_id=10303

 

The 10ft white one is only $1.34

post #5292 of 32897

Ok, the hype got to me, so I also ordered one ELE DAC. I chose the Hong Kong seller though as lately I've been really frustrated with the slow shipping from China.

post #5293 of 32897

not a bad idea, let us know how long they take.

...at that price! I think the dragonfly may be a good one to buy off amazon with the return option.


Edited by daveyostrow - 11/29/12 at 7:18pm
post #5294 of 32897
Quote:
Originally Posted by Zelda View Post

Quote:
Originally Posted by kiteki View Post

Wait wait, so you mean it's made in and shipped from like... Geneva, or Zurich... and not, err... Shanyang, or Zhengzhou?!

lol...kiteki...lol

 

anyway. for the ELE, which cable should i get? cant use the printer one

A printer cable will work well with this device.

post #5295 of 32897
Quote:
Originally Posted by dhL17 View Post

I'm using this one right now.

http://www.monoprice.com/products/product.asp?c_id=103&cp_id=10303&cs_id=1030301&p_id=5438&seq=1&format=2

 

Here is a list for all different colors and length.

 

http://www.monoprice.com/products/subdepartment.asp?c_id=103&cp_id=10303

 

The 10ft white one is only $1.34

 

Yeah, Monoprice is always ridiculously cheap on stuff like that, but shipping kills it for me. Amazon Prime FTW.

New Posts  All Forums:Forum Nav:
Head-Fi.org › Forums › Equipment Forums › Portable Headphones, Earphones and In-Ear Monitors › The discovery thread.! New NiceHCK DZ7 1DD+6 BA iem impression by ericp10. Page 2153