Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Tangent CMoy and Headphone Impedance
New Posts  All Forums:Forum Nav:

Tangent CMoy and Headphone Impedance

post #1 of 4
10/6/11 at 1:24am
Thread Starter 

I'm still new to the DIY amps, but I wanted to check what headphone impedance is safe to use with this amp. Will it be safe to use a 42 ohm headphone with them?

 

I'm not sure what information you need to know about my amp (which is still a work in progress) so if you need to know what resistors, capacitors, or op-amp I'm using I'd be happy to tell you. I'm using an Alps 10 kΩ RK097 POT if you're wondering.

 

Thanks in advanced for any help or suggestions you can provide!


Edited by miceblue - 10/6/11 at 1:28am
Reply
post #2 of 4
10/11/11 at 5:12pm

Yes, 42 ohms will be fine. 

Reply
post #3 of 4
10/11/11 at 7:32pm
Thread Starter 
Quote:
Originally Posted by Armaegis View Post

Yes, 42 ohms will be fine. 


Great, thanks a lot Armaegis! smile.gif

 

 

EDIT: Does anyone know where I can get a cheap, short male-male cable? I wanted to get one: 1. to test my CMoy circuit to make sure it works properly, 2. if I end up getting another PMP with a line-out jack, I could use it + my CMoy.


Edited by miceblue - 10/11/11 at 7:40pm
Reply
post #4 of 4
10/13/11 at 11:48am

Monoprice or eBay.  Or free with a Fiio E5 LOL.

Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Tangent CMoy and Headphone Impedance