Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › "Headphone power amp" - or how to connect cans to a regulated preamp-output (in casu: DNM primus preamp)
New Posts  All Forums:Forum Nav:

"Headphone power amp" - or how to connect cans to a regulated preamp-output (in casu: DNM primus... - Page 2

post #16 of 19
9/17/11 at 5:32am
Thread Starter 

Of course you can. From Switzerland. And you?

Reply
post #17 of 19
9/17/11 at 6:03am


 

Quote:
Originally Posted by ursdiego View Post

Of course you can. From Switzerland. And you?


 

As you can read here upside right, I'm from the Venetian countryside ;)

Grados are quite expensive on this continent... But you may not like the flatness of most German/Austrian headphones... It's up to you... :-)

Reply
post #18 of 19
9/17/11 at 6:09am
Thread Starter 

Nice! Yes, neighbour, I know, Grados have a rather unfortunate price strategy for Europe. However, I just did the winning bid on a RS-1 in the US over the bay, now I just have to see how I get it over here.

Reply
post #19 of 19
9/18/11 at 1:16am
Thread Starter 

I figure that "converting" a mid impedance line out to a low impedance headphone-driving-output might be a DIY issue. So I just opened a thread in the DIY section about the question:

 

http://www.head-fi.org/t/572245/convert-pre-amp-output-to-headphone-signal-or-how-to-lower-the-impedance#post_7762470

Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Headphone Amps (full-size)
Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › "Headphone power amp" - or how to connect cans to a regulated preamp-output (in casu: DNM primus preamp)