Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › on a standard Stereo Amp - where would you take the signal for an active sub?
New Posts  All Forums:Forum Nav:

on a standard Stereo Amp - where would you take the signal for an active sub?

post #1 of 2
9/7/11 at 6:11am
Thread Starter 

rec-out etc etc??

 

khushy

Reply
post #2 of 2
9/7/11 at 7:01am

If your stereo amp has no pre-out for sub then it means u have to use speaker wires from the amp to the high level input of the active sub, set crossover frequency and run the bookshelf speakers/satellites off the high level out of sub


Edited by trog - 9/7/11 at 7:03am
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Dedicated Source Components
Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › on a standard Stereo Amp - where would you take the signal for an active sub?