Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Grado stock cable question
New Posts  All Forums:Forum Nav:

Grado stock cable question

post #1 of 4
1/30/11 at 10:18am
Thread Starter 
I want to re-terminate my grado sr325is but I don't want to deal with opening the cups and all that, so I figured I could cut a few inches off the existing cable and just put a new plug on it. However, I don't know how the stock cable is wired and how the wires are colored if at all.

If you know what colors are used or have done this before any advice is appreciated
Reply
post #2 of 4
1/30/11 at 12:31pm

Surely you have a multimeter?

 

If you get truly lost you can poke a long & thin probe in through the back of the headphone mesh to contact the solderpads on the drivers.

Reply
post #3 of 4
1/30/11 at 4:43pm
Thread Starter 
Quote:
Originally Posted by nikongod View Post


Surely you have a multimeter?



 



If you get truly lost you can poke a long & thin probe in through the back of the headphone mesh to contact the solderpads on the drivers.




 



I do have a multimeter but didn't think of that thanks
Reply
post #4 of 4
1/30/11 at 7:41pm

Blue is ground

Red is right

White is left

Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Grado stock cable question