Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Need 3 stripe 3.5mm male end
New Posts  All Forums:Forum Nav:

Need 3 stripe 3.5mm male end

post #1 of 3
1/5/11 at 6:50pm
Thread Starter 

 wanna buy a shure headset for an iphone but it comes with 2.5 plug.  can you guys send me a link for a 3 stripe male end which i could solder on the end. what is the 3 stripe plug called?  will i have to replace the whole cable?  thanks in advance

Reply
post #2 of 3
1/5/11 at 6:54pm
Thread Starter 

also needs to be low profile to fit with case

 

 

http://www.markertek.com/Connectors-Adapters/Audio-Connectors/3-5-2-5mm-Mini-Connectors/171-7435-EX.xhtml


Edited by faxel - 1/5/11 at 7:14pm
Reply
post #3 of 3
1/7/11 at 8:04am

 

 

You found the name of the plug TRRS for Tip Ring Ring Sleeve.

 

You can just replace the plug on the end no need to replace whole cable.  If they used enameled wire you will need to get the enamel off the end to make a connection to your new plug.    Also, you might check online for the wiring in-case apple did their own thing. 

 

TRRS should be-

Tip: Left

Ring 1 (next to tip): Right

Ring 2: Extra Feature (Microphone, Video, etc)

Sleeve: Ground

 

I don't know who makes good TRRS plugs, so you will probably just need to search around until you find something that will fit your case.  It may be difficult to find ones as small as factory made ones.

 

Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Need 3 stripe 3.5mm male end