Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › Audinst HUD-mx1 vs HRT Music Streamer II vs Fubar II
New Posts  All Forums:Forum Nav:

Audinst HUD-mx1 vs HRT Music Streamer II vs Fubar II

post #1 of 8
12/22/10 at 7:35am
Thread Starter 

I've been looking for a DAC around the 180 price range and I've gotten it down to these three, but I'm having a hard time deciding which one to get. I'm also open to new ideas, but I mainly want to hear about these three. Thanks

Reply
post #2 of 8
12/22/10 at 8:44am

my take on this dilemma:

-the audinst has a nasty sounding OPA2134 soldered on its line-out

-I think the HRT provides galvanic isolation over USB from what its manufacturer said here on head-fi

 

there used to be a discount on the new Spitfire MKII DAC, but it's apparently over in the US.

Reply
post #3 of 8
12/22/10 at 9:15am

http://www.headfonia.com/the-hrt-music-streamer-ii-asynchronous-2496-for-149-95/ this review has the comparison that you might wanna read regarding the Audinst and the HRT MSII. The conclusion might give you a good hint on where you should go. As for the Fubar II I have no idea about it though. Overall, it's important to decide on an audio gear on how does it sound and which functionalities it provides at your price point, a single chip does not make the whole thing sounds absolutely bad or good.

Reply
post #4 of 8
12/22/10 at 9:25am

Your review says "Most notably is the soundstage depth, where the MS2 is much more three dimensional than the Audinst", sounds like a bad case of teh 2134's.

 

Too bad the PCB shots of the HRT are so small, this looks nice: galvanic isolation, PCM1793, swappable opamp, async drivers. No wonder it's being so praised. The only thing it seems to lack is a proper DPS.

Reply
post #5 of 8
12/22/10 at 10:14am
Thread Starter 

I actually saw that review and I guess he leaned more towards the MSII, but I still wasn't too sure. I think I'll rule out the Audinst now though.

Reply
post #6 of 8
12/22/10 at 10:53am

It depends whether you want a DAC or a DAC/amp combo, if a DAC only then obviously the MSII, otherwise the Audinst has more value for an entry setup.

Reply
post #7 of 8
12/22/10 at 11:01am
Thread Starter 

I see what you mean. I have a PA2V2 that I can hook up to the MSII at least temporarily until I upgrade so I think I'll go with the MSII

Reply
post #8 of 8
12/25/10 at 4:01am

I use the MSII and while I dunno if what I do is safe or not, but I run my Sennheiser HD650 cans straight out of the MS II (RCA -> 3.5mm adapter).

 

Sounds almost as good as out of my Compass amp.

 

I am sure driving a 300 ohm can is safe but I dunno about driving more efficient cans.


Edited by brendon - 12/25/10 at 4:03am
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Dedicated Source Components
Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › Audinst HUD-mx1 vs HRT Music Streamer II vs Fubar II