Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › Getting the most out of Maverick A1
New Posts  All Forums:Forum Nav:

Getting the most out of Maverick A1

post #1 of 3
11/20/10 at 10:37am
Thread Starter 
Hi all, I'm used Mav A1 for about a month now and the A1 had been "Break in" for more than 100 hours already. I hooked up Mav A1 to CD player out, from Mav A1 to 60Wiatt 8000s act as a preamp. From 8000s to 70Wattt Arcam 900D power amp and drive speakers. I noticed MAV A1 sound good with headphone(Beyerdnamic DT880) directly from MAV A1 headphone output jack but from headphone of Audiolab itsound a bit dulls and with Arcam Powe amp headphone output jack it sound slightly beter. With Mav A1 in the line, listening with speakers i did not get significant improvement. Did my set up to much with audiolab 8000s in between which is solid state amplifier which caused signal lost ? Can I connect Mav A1 after Audiolab 8000s before feed to arcam Powe amp? Which set up can prevail the best of Mav A1....? thanks.
Reply
post #2 of 3
11/20/10 at 11:10am

I honestly have no clue what you're talking about. I think you would be better of asking it in the A1 tread (which you did in the mean time)

Reply
post #3 of 3
11/20/10 at 3:54pm
Thread Starter 

Sorry to confuse you, oh my bad English again. 

What I simply mean that if I have overdo it hooking Mav A1 that way, CD + Mav A1 + AudioLab 8000s (Pre amp) + Arcam (Power Amp) + Speaker.

If this caused signal lost adding Audiolab 8000s? Thank you anyway, I'll try Mav A1 tread....

Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Headphone Amps (full-size)
Head-Fi.org › Forums › Equipment Forums › Headphone Amps (full-size) › Getting the most out of Maverick A1