Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › Replacing the motor suspension band on the Pro-Ject Debut III
New Posts  All Forums:Forum Nav:

Replacing the motor suspension band on the Pro-Ject Debut III

post #1 of 3
10/23/10 at 2:23pm
Thread Starter 

I noticed that mine had snapped, and so ordered a new one. Got out the screwdriver and pulled out the screws that attach the motor to the metal plate, between which the band rests (the metal plate is what screws onto the plinth for travel). So I pulled out the old band, put in the new one, went to screw it back together and...the metal plate doesn't screw into the motor's brackets anymore. The metal is too strong to have bent without my noticing, but I have no idea what changed and why I can't get it back together again. Can anyone help?

Reply
post #2 of 3
10/23/10 at 2:37pm
I'm not familiar with the Pro-Ject decks, but see if you can find the manual over at the Vinyl Engine. They also have forums where you might find an answer or could ask someone.

Good luck with your deck.
Reply
post #3 of 3
2/20/11 at 1:22pm
Quote:
Originally Posted by Uncle Erik View Post

I'm not familiar with the Pro-Ject decks, but see if you can find the manual over at the Vinyl Engine. They also have forums where you might find an answer or could ask someone.

Good luck with your deck.




It's comprehensive, Thanks for your sharing! It is just the solution for my problem.
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Dedicated Source Components
Head-Fi.org › Forums › Equipment Forums › Dedicated Source Components › Replacing the motor suspension band on the Pro-Ject Debut III