Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Mogami 2534 Question
New Posts  All Forums:Forum Nav:

Mogami 2534 Question

post #1 of 2
10/14/10 at 1:04pm
Thread Starter 
I'm going to attempt to recable my d2000s tonight, using Mogami 2534...now, there are 2 clear wires and 2 blue wires- after soldering the conector, how do I distinguish the R channel from the L channel? Its impossible to follow the wire from the connector, as it is shielded, I fell like I'm left with a 50/50 shot- could I use a DMM? And if so, how?

Thanks
Greg
Reply
post #2 of 2
10/14/10 at 1:20pm

Take the DDM and set the mode to measure resistance. Then touch the contact of the connectors with one probe and wires on the other end with the other probe. Read other wires till the resistance drop to a minimum. That means that wire is connected to that contact.

Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Mogami 2534 Question