One amp, or multiple?

I have three amplifiers.

One for the office rig, and two for the home rig.

 

Why? Well, first of all bringing an amplifier to work and back is too much hassle, so at least two units are needed. Second of all it is nice to have two units at home, as they do perform differently with different pair of headphones.

I currently have one tube amplifier and one solid state. Recently had three solid states. Differences wheren´t all that great on the solid states. 

 

The tube amp do go about things a bit differently though so it was not a hard decision to keep that one. Plus it has features that is hard to come by as dual inputs, preout and SUB out. Cut down my Solid state amp collection as well since they where more competing them complementing eachother.

 

 

 

Multiple amps. I like the variety of tubes and circuits out there, so I went a little overboard. They're fun to build and learn about.

If I had to narrow down, I'd keep one OTL and one transformer-coupled tube amp as well as a competent solid state amp. That would give me enough variety. Oh, and a 'stat amp, too.

Mulitples, for much the same reasons as Uncle Eric.

Have yet to have two of anything side by side and liked both the same.  So for me, the better stays, the weaker goes.  Ie going through my can amp history... Meta42 had nothing to offer against the HeadAmp Lite so I sold it, Rudi 5.1 was better in some areas than the Lite so bye bye Lite.  HeadAmp Reference beat out the Rudi and the SFT Dynahi so stuck around for a while.  Now back to dynamics, the Concerto didn't offer anything the B22 didn't do better so gone.  I've love to try a top level tube amp in house but they just aren't toddler friendly or look like they stepped off a retro catalog =P

No, it is moving coil.

It is designed to be run from a speaker amplifier though.

High impedance phones generally sound good with OTL tube amp and low impedance phones with transformer coupled.

 

Tube amps will give you a warm sound and solid state amps will be more analytical in sound. All depend on your taste for different and choice in sound signature.

That's a good reason to build your own, as well. A much wider variety of circuits is available if you DIY and you'll save plenty if you supply your own labor. It also lets you choose the parts you want to go into it.

Audiogalore, transformer-coupled tube amps usually do great with high impedance headphones, too. There will be a high damping factor usually, which is a good thing. The reason more transformer-coupled amps aren't on the market is because quality output transformers tend to be expensive. Generally, you're going to spend at least $200 on those alone. But you can spend a lot more - some of the headphone-specific transformers from Sowter will cost you $500, not includimg the rest of the parts for the amp.

Also, not all OTL amps do badly with low-impedance headphones. The Zana Deux has a low output impedance thanks to the 6C33C tubes.

I have one OTL and one SS amp for my low impedance cans. I am out of room or I would get a transformer coupled tube amp as well for my low impedance cans.

I keep several amps for their different sound flavors and for their different performances when coupled with different headphones.

 

I think it's wonderful to have different amps in different locations, like the family room, bedroom, home office, or at work.  However, I unless you have spending cash, I don't recommend having more than one amp in one listening area.  If you desire different sounds from a particular amp, try a tube amp and roll some tubes, or get an equalizer.  Having multiple amps is certainly a luxury, but I'd rather put extra money towards more music.