SE 535 BROKEN NOZZLE

Olive-nozzle-breaking isn't what we haven't seen before. There are a few cases reported on the old SE530. You should contact Shure and tell them about it, It should be covered by warranty, as similar to the cases with SE530. Shure doesn't repair. Once they receive yours, they usually will just replace the broken side.

I have been really worried about this happening with my 535's.  I too have had difficulty getting the black olives off the nozzle.  It actually did happen with my E5c's with custom tips on, when they were somehow subjected to pressure, despite being in their hard case.!  The nozzles are a point of physical weakness in Shure's design.  I wish they had used Kevlar or some such to mold the bodies.

Yes the olives on mine are very tight I have to bite them off with my teeth. I'm sure Shure will have to replace mine in the near future or pay my dentist bill :)

pry the core up from the bottom near the base, one side then the other to get it started. When you grab and pull/twist you're also squeezing them against the nozzle. Once you break them free from underneath, the come of pretty easy.

put them in the freezer for 10 minutes before removing the tips and gently twist them off.

works like a charm and i got this info from a shure rep.

wait for them to warm up before playing them as there is a difference in  the storage vs. usage temperature ranges.

I live in Vermont.  While the summer has been pretty hot, quite soon it will be cold again.  No need for the freezer, ambient temps will do.  Thanks for the hint.

Quote:

Originally Posted by Bradan 

put them in the freezer for 10 minutes before removing the tips and gently twist them off.

 

works like a charm and i got this info from a shure rep.

 

wait for them to warm up before playing them as there is a difference in  the storage vs. usage temperature ranges.

I thought putting electronics in the freezer was bad.  Water could condense and screw your earphones.

Right, so Shure's flagship iem requires putting in the freezer to remove the tips safely?  Way to go Shure!
 

Quote:

Originally Posted by Bradan 

put them in the freezer for 10 minutes before removing the tips and gently twist them off.

 

works like a charm and i got this info from a shure rep.

 

wait for them to warm up before playing them as there is a difference in  the storage vs. usage temperature ranges.

If you are concerned about tight fitment, stretch out the Olive core before using.  The plastic gets flexible when heated, and you can dip them in hot water for a little bit to soften them up.  From here you can take a small screwdriver, an end of a pen or pencil and flex open the core some.  To give you a scale of what can be done, I've fitted an Olive tip, with core, over a Triple.Fi 10 nozzle.  It had to be cut off, but you get the idea of what you can do with the Olive if you want. 

Mines was only tight and hard to get off the first time when I took them out of the box. After that they were really easy to twist off.

This was one of the major problems I had with the SE530's when I bought them. I mean the sound wasn't for me either, but the impossibility presented by trying the other tips really put me off keeping them for very long too. Why on earth have they been designed to fit so tight? 

Quote:

Originally Posted by Bradan 

put them in the freezer for 10 minutes before removing the tips and gently twist them off.

 

works like a charm and i got this info from a shure rep.

 

wait for them to warm up before playing them as there is a difference in  the storage vs. usage temperature ranges.

Beat me to it. Exactly...I would say only 3-5 minutes should do the trick very nicely.

It's worked for me like a charm.