New Posts  All Forums:Forum Nav:

FS: Headphile CPU mini to mini copper 25cm

post #1 of 5
Thread Starter 

This is cable is new - I have merely tested after receipt to ensure it works properly. It's the Headphile "CPU" series cable (copper) and is a 3.5mm stereo mini to 3.5mm stereo mini configuration. 25cm total length.

 

Postage at cost to anywhere in the World. Cost of postage will depend on the postage method used and whether you are prepared to accept responsibility if it gets lost in the post. The safest method for outside of Australia is Registered International and this would run at around $25 AUD posted to the US for example. I can send it much more cheaply than that (for example in a relatively nastly bubble wrap lined envelope for example, but it wont be insured against loss, won't be super-protected and will just get dumped at your doorstep. But it is much cheaper too...Probably not an option for countries such as Italy though where things seem to get lost in the post more than normal...

 

Asking $40 AUD for the cable excluding postage.


Edited by ADD - 7/30/10 at 12:50am
post #2 of 5

Is this a 3,5 mini to 3,5 mini i can use between ipod (source) and headamp?

Qiality cable? And just for order sake 25 cm right? (not 2,5cm)

Any perticular performance? (Sound? bright dark etc?)

post #3 of 5
Thread Starter 

It's primarily designed to be used to connect two soundcards in a PC where noise generation (motors, hard drives, etc) could add noise to the signal. You could certainly use it for what you want if the input on your amp is a 3.5mm stero mini and the cable is built quite tough for that sort of use / abuse. I would simply describe the cable as adding clarity and detail over a cheap interconnect cable you would buy at an electrical store but otherwise it is basically neutral. 

 

The cable is built very tough and well engineered. Some may argue they are not the prettiest. You can can see them on the Headphile website. Length is 25 cm as in one quarter of a metre.


Edited by ADD - 7/30/10 at 1:57pm
post #4 of 5

Aha...

Picture of one end please?

 

rgds

P

post #5 of 5

..on second thoughts its probably to short as a interconnect for a micro system and to long for a portable??

hmm?

Ill think about it..

rgds

Patrick

New Posts  All Forums:Forum Nav: