@atraf : The third lockwasher is used on page 14. The starred terminals will vary from meter to meter. As long as you are not getting 0Ω and your capacitors are installed as shown in the manual, you should be fine. As for your resistance checks, they are all within 10%, and therefore fine.
Thank you for you reply so where is the first 2? :O in the ground screw? it already came with one washer .. I am clueless.. In page 14 its said I should put one in the transformator screw and I did..
Ok time for voltage testing :O
Ok i just noticed its a small lock washer not large, my bad.. I will go over my steps.
Edited by atraf - 8/2/14 at 10:14am