New Posts  All Forums:Forum Nav:

Case for Opus Dac

post #1 of 3
2/27/10 at 7:09pm
Thread Starter 
Hi

I was looking around for a metal/aluminium case for my Opus Dac that i just built.

I was looking at the standard hammond cases but i don't think the pcb's fit into the slides..

The Dac is three Pcb's that can be stacked on top of each others:
Opus - A Balanced DAC
Low Current Dual Power Supply (LCDPS) - A Dual Regulated CLRC Supply
The USB DAC/Receiver

So, anyone got some cases that would go with this?

The Pcb's are 8.3cm L x 5cm W
Reply
post #2 of 3
2/27/10 at 7:50pm
I stumbled upon these. If you stack the PCB they should be able to fit. If you put an IVY III in there it may be a bit cramped due to the toroid transformers.
Reply
post #3 of 3
2/28/10 at 8:37am
Thread Starter 
Quote:
Originally Posted by ShinyFalcon View Post
I stumbled upon these. If you stack the PCB they should be able to fit. If you put an IVY III in there it may be a bit cramped due to the toroid transformers.
That looks like something i could go for. But how exactly will i fasten the Pcb's screw them to the bottom of the case or?
Reply
New Posts  All Forums:Forum Nav:
  Return Home