Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Help. y1 Full ++ mated to y2 not recognized.
New Posts  All Forums:Forum Nav:

Help. y1 Full ++ mated to y2 not recognized. - Page 2

post #16 of 21
2/9/10 at 10:02pm
Thread Starter 
I used 296-1091-1-ND from DigiKey.
Reply
post #17 of 21
2/9/10 at 10:13pm
Hmm, I wonder if Digi-key sent you the wrong part. Texas Instruments SN74AHC1G08DBVR should have marking "A08_" where _ is a factory code.
Reply
post #18 of 21
2/9/10 at 10:16pm
Thread Starter 
Well that would be a cheap fix! I'll order another (perhaps from Mouser) and try that.
Reply
post #19 of 21
2/9/10 at 10:19pm
The NXP part is also marked AO8 (or at least the ones I have in front of me are).
The part you have installed doesn't look like a SOT-23-5 chip either so....
Reply
post #20 of 21
2/11/10 at 2:12pm
Thread Starter 
U2U was in fact the wrong part! Correct part installed and now working. It sounds fantastic! Thanks everyone for all of your help!
Reply
post #21 of 21
2/11/10 at 2:58pm
That was pretty quick. Digi-key customer service or did you order one from another supplier?
Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Help. y1 Full ++ mated to y2 not recognized.