I wanted to build a powerfull yet small amp to go with My Clip+.
What I wanted was a digital POT, Lithium ion battery and enough oomph to drive a set of full sized cans...
So what I ended up with was this, its powered by a 7.4v (8.4 on a full charge) 430ma battery, uses a DS 1802 Digital POT with illuminated NKK push button switches for volume controll.
It is just a hair bigger than the Clip+, but initial impressions are that is sounds realy good! I wasn't sure how it would sound but I am plesantly surprised.
In the pics you will note that it is not fully assrmbled yet, I am still waiting on the DS1802 and a couple other parts for the volume control. So right now I have just been listening to it with the DPOT shorted.
The PCB was designed on Express PCB, and is a 4 layer board.



What I wanted was a digital POT, Lithium ion battery and enough oomph to drive a set of full sized cans...
So what I ended up with was this, its powered by a 7.4v (8.4 on a full charge) 430ma battery, uses a DS 1802 Digital POT with illuminated NKK push button switches for volume controll.
It is just a hair bigger than the Clip+, but initial impressions are that is sounds realy good! I wasn't sure how it would sound but I am plesantly surprised.
In the pics you will note that it is not fully assrmbled yet, I am still waiting on the DS1802 and a couple other parts for the volume control. So right now I have just been listening to it with the DPOT shorted.
The PCB was designed on Express PCB, and is a 4 layer board.









