New Posts  All Forums:Forum Nav:

Olimex changes

post #1 of 3
1/19/10 at 11:41am
Thread Starter 
Olimex has improved since I last used them. The component printing looks better. They are using immersion gold as the old plating was not RoHS. Minimum width for component printing is now 5mils.

Trace/Space is still 8 or 10 mils and the drill rack policy is unchanged.

You can see how much better the component print looks. The 0207 resistors are done with a 10mil wide library. Just about everything else is 6 mils wide.

This headphone amp/mixer/switcher is not an audiophile project. Response is poor by design.

Reply
post #2 of 3
1/19/10 at 4:07pm
This pcb looks a lot better than this which I got as a sample. It looked a lot worse than in the picture.
Reply
post #3 of 3
1/19/10 at 9:45pm
The print was always a bit off center before, but on my latest order it was dead-on. Nice to see they are getting better.
Reply
New Posts  All Forums:Forum Nav:
  Return Home