Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › HE60 retermination stator orientation Q
New Posts  All Forums:Forum Nav:

HE60 retermination stator orientation Q

post #1 of 4
1/8/10 at 8:30pm
Thread Starter 
So I am getting ready to reterminate my HE60, I am unsure of the pinout though. I found the HE60 pinout, but I am not sure if + is the front or back stator. Anyone know for sure? Maybe someone has replaced the drivers and spied the color of the cables going to each stator.

thanks,

serge
Reply
post #2 of 4
1/8/10 at 8:41pm
Red is R+, Yellow is L+, Green is R-, Blue is L- and Black is bias. The + stator is the one closer to the ear.
Reply
post #3 of 4
1/11/10 at 9:40pm
Thread Starter 
Thanks spritzer. I have another question that you may be able to help me with. I am installing some new drivers. I may have left out a piece though as the fit is kind of loose. I installed in this order: the cup/suspension/driver (shiny side towards the ear)/mesh cup backing. The driver isn't held in place very tightly, also I can't figure out where the o-rings go. Any insight appreciated.

thanks,
serge
Reply
post #4 of 4
1/12/10 at 4:50am
The o-rings are held in place in the 4 corner slots inside the cups. If you look at the back of the drivers then there are guides for the o-rings molded into the plastic which will help you see where it all should be.
Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › HE60 retermination stator orientation Q