Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Grado sr-80 mod idea.
New Posts  All Forums:Forum Nav:

Grado sr-80 mod idea.

post #1 of 6
10/22/09 at 10:01pm
Thread Starter 
I was wondering if it was possible to make a removable cable design for them.
Reply
post #2 of 6
10/22/09 at 10:05pm
Yes, already done, see headwize library.
Reply
post #3 of 6
10/22/09 at 10:06pm
Thread Starter 
oh i see, my search didn't turn up anything.. I guess i should buy a soldering iron and some cables and use my hd 212s as tests to see if i could do it.
Reply
post #4 of 6
10/22/09 at 10:36pm
HeadWize - Project: The Collected Grado Headphone Mods by "Skippy" et al.

Definitely a good idea to get a soldering iron and start modding, have fun
Reply
post #5 of 6
10/22/09 at 11:04pm
Thread Starter 
would the mod change the frequency response or affecting anything?
Reply
post #6 of 6
10/23/09 at 9:20am
Shouldnt as long as the soldering is good. The only bad thing you are doing is adding more contacts, which could cause degradation If they get dirty or corroded. Also the signal now goes from copper to can, to copper, solder, nickel, brass,nickel,brass,solder, then back to copper. As the old saying goes, the best connector is no connector.
Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Grado sr-80 mod idea.