Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › If it's possible how do I make a stereo mini -> 2 speaker cables?
New Posts  All Forums:Forum Nav:

If it's possible how do I make a stereo mini -> 2 speaker cables?

post #1 of 6
7/4/09 at 6:34am
Thread Starter 
If it's possible how do I make a stereo mini -> 2 speaker cables (not how you solder but which colored wire go to which solder point)?
I think it is possible (i believe 1 of the connectors is a ground but am not 100%)
Is the red or black connector on a speaker the ground?
Reply
post #2 of 6
7/4/09 at 6:57am
stereo mini: tip is left channel, middle is right and base is ground.
speaker: black cable is ground red one is signal.
With a cheap multimeter, this should be enough to get it right
Reply
post #3 of 6
7/4/09 at 7:02am
I don't understand what possible use a mini to speaker termination would have.
Reply
post #4 of 6
7/4/09 at 7:03am
Thread Starter 
thanks exactly what i was looking for + more. thx

for a person without an amp at the moment.
Reply
post #5 of 6
7/4/09 at 7:18am
you may want to read wikipedia about the mini stereo. there are some things to watch out for, like current draw, shorting when plugging in...
it takes 5 minutes but may well save a piece of equipment.
Reply
post #6 of 6
7/5/09 at 9:19pm
Thread Starter 
k thx
Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › If it's possible how do I make a stereo mini -> 2 speaker cables?