Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Parts Suppliers (Molded Cable Grips, or suitable plugs and jacks)
New Posts  All Forums:Forum Nav:

Parts Suppliers (Molded Cable Grips, or suitable plugs and jacks)

post #1 of 2
4/19/09 at 5:46pm
Thread Starter 
I'm getting ready to recable my K701's with some Crystal Cable that I obtained. I have been searching for someplace to get Molded Strain Reliefs or Molded Cable Grips or Strain Relief Grommets that would be suitable. The Crystal Cable is small wire, the O.D. is only 1.75 mm so it's a small molded item that I'd be looking for. I've found places that will make custom pieces, if only I needed Ten Thousand.

I've also considered going with a small plug and jack arrangement such as that used on the K-702 but I haven't found a supplier for that either.

Any help would be appreciated.
Reply
post #2 of 2
4/25/09 at 3:07pm
make them yourself out of epoxy putty, lucky you on the piccolino. its great stuff; your gonna love it.I ended up using the eichmann grommets for my RCAs and clear PVC tubing covered in adhesive heatshrink for others. also made some with the putty I mention. you can get it in black; made by a company called milliput
Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Parts Suppliers (Molded Cable Grips, or suitable plugs and jacks)